Spin S4000 4-Piece Drill Bit Swaging Set, 1/4, 3/8, 1/2, 5/8"
Spin S4000 4-Piece Drill Bit Swaging Set, 1/4, 3/8, 1/2, 5/8"
From the manufacturer
Swaging SPIN:
Forms soft and rigid copper. Using the Swaging SPIN you will have half the braze joints, decreasing drastically the probability of leaks. You save money by dispensing additional fittings. The Spin tool is designed to deliver an ideal swage depth to each tube diameter.
*Minimum Requirements
All SPIN Tools are designed to work with drills and/or screwdrivers, with a minimum of 1,800 RPM and 500 watts, for corded drills, or superior and 1,800RPM and 18V, or superior, for cordless drills.
HOW TO The 5-Second Swage: An Illustrated Guide Featuring How Effortless It Is To Use The SPIN Tools
|
|
|
|
|
|---|---|---|---|
|
FASTEN the Swaging SPIN Tool into the drill’s chuck. Ensure it’s on tight. FIRMLY hold the tube at all times. Use your other hand if needed. Important: Use rotary mode only. Hammer/impact mode will damage the tube. |
Keep the drill at MAXIMUM SPEED, at all times. ALIGN the tube and drill. INSERT the Swaging SPIN. Maintain a CONSTANT PRESSURE through the process until the tool stopper has met with the tube. |
Keep the tube and drill ALIGNED. Keep the drill at MAXIMUM SPEED. PULL OUT the Swaging SPIN from the tube. REMEMBER: this swaging process is an “in-and-out” sequel that is approximately 5 to 7 seconds. |
Immediately after, the tube’s temperature is very high. Don’t touch the swage until the tube has cooled off. FINAL RESULTS is an expansion with just the right depth and diameter to accommodate the other tube. |